density and surface area of Ammoniacal Colloidal Silica

The density and surface area of Ammoniacal Colloidal Silica can vary depending on the specific grade and formulation of the product. These properties are often specified by the manufacturer and can be tailored to meet the requirements of different applications. Here are some approximate values:

Density: The density of Ammoniacal Colloidal Silica is typically close to the density of water, which is approximately 1 gram per milliliter (g/mL) or 1000 kilograms per cubic meter (kg/m³) at standard conditions (20°C or 68°F and 1 atmosphere of pressure). However, the actual density may vary slightly depending on the specific concentration of silica particles and other additives or stabilizers in the product.

Surface Area: Ammoniacal Colloidal Silica is known for its high surface area, which is one of its key characteristics. Surface area is often measured in square meters per gram (m²/g) or square centimeters per gram (cm²/g). Typical values for the surface area of Ammoniacal Colloidal Silica can range from 50 m²/g to over 300 m²/g, depending on the grade and intended application. Higher surface area colloidal silica products are often used in applications where high surface area is desirable, such as catalyst support materials or as a binder in coatings.

It's important to note that the precise density and surface area of a specific Ammoniacal Colloidal Silica product should be obtained from the manufacturer's product specifications, as these properties can vary between different grades and formulations. Silica Sol Suppliers often provide detailed technical data for their products, including information on density, surface area, particle size distribution, and other relevant properties to help users select the right product for their intended applications.